1. Solder: The wiring design and soldering method should avoid causing the molten tin to flow to the plane of the PC board, which will cause poor contact.
2. Slide handle length: the shorter the length, the better. In the case where the width A of the slide handle is unchanged, the shorter the slide handle length, the better the feel, and the higher the output point, the worse the feel.
3. Use flux with caution: Avoid using water-soluble flux when soldering, otherwise it will have an adverse effect on the metal and other materials that constitute the toggle switch.
4. Use chemicals cautiously: Since synthetic resin such as polycarbonate is used for the toggle switch bottom plate, it should avoid exposing the potentiometer to strong chemicals such as ammonia, amine, alkaline solution, threonine, ketone, ester, halogenated hydrocarbon, etc. In the atmosphere.